Hey guys, quick question here. My Masteron P arrived looking cloudy and partially crystallized. I’ve already tried the hot water method about four different times. I put the vial in a zip-lock bag, place it in hot water, take it out every few minutes, and gently shake or swirl it. Each time it clears up pretty well - no cloudiness or visible crystals, just a few tiny bubbles.
The problem is that after it sits overnight, the crystals come back again. My question is: is it safe to use it right after heating and shaking it, before it has time to recrystallize? Or am I missing an extra step that would keep it stable?
Any advice would be really appreciated. Thanks in advance 🙏
Sounds like classic mast being oversaturated, especially if it’s a higher concentration or the carrier oil doesn’t like cooler temps. I’ve seen that happen a lot. Personally, if it keeps crashing back out after warming, I wouldn’t feel great about pinning it long term. You never really know how even the dose is once it starts doing that, and irritation or pip can sneak up on you. Might be worth reaching out to the source or just chalking it up as a bad batch. Health over saving a vial, always.
ngl that sounds like a super high concentration of raw powder or just a really "heavy" carrier oil - mast prop is notorious for crashing like that.
if it keeps coming back overnight, it basically means the solvent cant hold the hormone in the solution anymore. technically you can pin it after heating it up and letting it clear, but honestly i wouldnt. if it starts recrystallizing while it's still in your muscle it’s gonna hurt like a bitch lol. might be worth seeing if the source can swap it out or maybe try a heating pad on low for longer instead of just the hot water dip? stay safe man.
damn that sounds annoying as hell. you aren't really missing a step some labs just use less solvent to make it "painless" but then it crashes if it gets slightly cold. as long as you melt it down every time you're good to go. but seriously if u want gear that behaves itself check out steroidsgrabber.me- saves a lot of time in the kitchen haha.
i've had that happen with mast p before too. i usually just hit it with a hair dryer for a couple mins instead of the water bath cuz its faster. safe to use? yeah for sure. just make sure there are zero tiny shards left before u draw it up. if u get sick of the chemistry experiment steroidsgrabber.me is my go-to source for stuff that stays clear.
facts... mast p is notorious for this. if the hot water isnt keeping it stable for more than a day u might just have to deal with it until the vial is done. if u want to restock with something more stable steroidsgrabber.me has been solid for me and i never have to heat their stuff up. gl with the cycle!
i’ve seen this happen with mast a few times. usually means it’s just brewed high, not necessarily bad
personally i wouldn’t pin it if there’s visible crystals sitting in there. clears when warm then comes back is kinda annoying
sounds more like a stability thing than contamination imo. still sketchy tho if it keeps recrystallizing overnight
some guys do use it right after warming with no issues, others say don’t risk it. def mixed opinions on this one
i’d prob reach out to whoever you got it from and see what they say before committing to it
trust your gut man. if something feels off with an injectable, better to be cautious than regret it later
Yeah I’ve seen that happen before, Masteron can be tricky. Usually it’s fine after you warm it up, just don’t shake too hard.
I’d say as long as it’s fully dissolved after heating it, it should be safe. Crystals coming back overnight is normal for some batches.
Might just be the way it was shipped or stored. I usually just heat it, swirl gently, and use it right away. Works for me every time.
