I've got a couple of 10mL vials of Mast P at 200mg/mL, and after just a few weeks, both of them have started crystallizing. I've tried the whole hot water bath trick, but I just can't get the crystals to fully dissolve no matter what I do. It's weird because I've already started using one of them while the other is still sealed, yet they both crashed even though I keep them inside where it's always at least 72 degrees.
I grabbed these from a pretty well-known source on the underground forums, so I'm trying to figure out if this is just a common issue with high-concentration Mast P or if I should just find a new source next time. Has anyone else dealt with this specific brand or dose crashing like this? I'm not sure if there's a trick I'm missing or if the brew is just messed up.
if the hot water bath isn't working you might need to try a hair dryer on high heat for like ten minutes or even put it on a coffee mug warmer if you have one but just be careful not to melt the label off lol. honestly though even if you get it back to clear it is probably just going to crash again by the next morning because the brew is just too saturated. that pip is probably going to be a total bitch too with all that solvent in there. next time i would just stick to the 100mg stuff because it is way more stable and you won't have to spend half your morning playing chemist just to get a shot ready!
200mg/mL mast p is kinda pushing it tbh, that stuff loves to crash when it’s brewed that high. i’ve had the same thing happen even with decent sources, especially if the solvent mix isn’t dialed in perfectly.
if even sealed vials are doing it then that pretty much screams brew issue more than storage. not necessarily fake or bad, just overdosed or solvent balance kinda sucks.
200mg mast p is exactly where a lotta brews start flirting with “looks good on paper but acts dramatic as hell in the vial” lol. some labs absolutely push concentration harder than the solvents really wanna support so crashing doesnt always mean fake, just kinda overambitious brewing. if both vials did it even sealed that definitely sounds more like the formula than anything you did. honestly i’d trust a smooth lower concentration over crystal science project gear any day because fighting your oil every week gets old real fast.
200mg mast p is kinda already flirting with “yeah this might get weird” territory from what i’ve seen lol. prop at that concentration can definitely be more crash prone, so it doesn’t automatically mean your source is trash but it also wouldn’t exactly fill me with blind confidence either.
heat helps but if it keeps re-crystallizing it usually means the solution just isn’t holding the compound properly long term
not gonna lie sometimes the “popular forum source” stuff crashes more than the smaller labs because everybody wants these crazy high mg numbers for marketing 😂
yeah this happens more than people admit with mast p at 200mg
